![]() ![]() The pulley-less bridle system offers a more dynamic and direct feel to the kite and a. The short term trim rate of change can be altered in order to produce better operation under closed loop, both for a normal oxygen sensor input and when using a wideband lambda input. Check out the benefits of your new EVO SLS: best allrounder. The minimum and maximum short term adjustment sets the limits for the short term fuel trim in the same way as the long term settings. ![]() 10% means that the short term fuel trim will not remove more than 10% fuel from the table. The values are expressed as a percentage adjustment of fuel eg. The minimum and maximum long term adjustment sets the limits for the long term fuel trim. Note that a value of 99% will disable open loop from TPS position. There are two tables - High is the switch from closed to open loop and Low is the switch from open loop back to closed loop. ![]() Ecological sanitation systems or ecosan, intended to close the nutrient and water cycle. Maximum engine speed is the maximum rpm for closed loop operation.ĭelay after engine start is the delay after starting the engine before the ECU will start to run in closed loop.Ĭlosed loop max TPS is the throttle position switch point from closed loop to open loop operation. Closed-loop communication, a communication technique used to avoid misunderstandings. Maximum Map for closed loop determines the maximum engine load for closed loop operation. Normally it is around 2.35V.ĭisable the o2 heater if the stock oxygen sensor is physically present. Wideband target voltage is the target wideband voltage. Narrowband target voltage is the target oxygen sensor voltage when using the stock oxygen sensor. The wideband input pin and target lambda are specified in Closed Loop Advanced Parameters. This setting uses a wideband lambda voltage input as the oxygen sensor input, with a dynamic lambda target. Ĭlosed loop - wideband input (target lambda) See Wideband target voltage and Closed Loop Advanced Parameters. This setting uses a wideband lambda voltage input as the oxygen sensor input, with a simple voltage target. This is the normal setting with the stock oxygen sensor.Ĭlosed loop - wideband input (voltage target) Otherwise the ECU will adjust the air/fuel ratio resulting in an inconsistent air/fuel ratio. Closed loop when the ECU uses an oxygen sensor input to alter the air/fuel mixture in order to achieve maximum fuel and catalytic converter efficiency.Ĭlosed loop operation may be one of the following options: These parameters control closed loop operation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |